RAYPAK

3G Electric stocks Raypak pilot assemblies for both natural gas and natural/propane lid gas applications. The natural gas pilot assembly is identified by manufacturer part number 002234F, while the dual-fuel version uses part number 002003F. These assemblies are designed for direct replacement in Raypak heating systems, ensuring proper flame ignition and safety. They are compatible with specific Raypak boiler and pool heater models, so verify your unit's part number before ordering.

Raypak ignition control boards, such as part number 009057F, are rated for 120V and designed to manage the ignition sequence in gas-fired heaters. To identify the correct board, check your existing unit's manufacturer part number, which is typically printed on the board itself. 3G Electric supplies this specific board as a replacement for Raypak systems that use a hot surface igniter or spark ignition. Ensure voltage and wiring configuration match your system to avoid compatibility issues.

The Raypak flow switch (part 007142F) is a safety device that monitors water flow through the heat exchanger. It prevents the burner from firing if flow is insufficient, protecting against overheating and damage. This switch is commonly used in Raypak pool heaters and commercial water heaters. When replacing, ensure the flow switch is rated for the system's flow rate and pipe size. 3G Electric stocks this part as a direct OEM replacement.

The Raypak hot surface igniter (part 007400F) is designed specifically for Raypak heating systems that use silicon carbide or silicon nitride igniters. It is not universal; compatibility depends on the igniter's voltage, resistance, and mounting configuration. Always verify that your system's manufacturer part number matches 007400F before installation. 3G Electric supplies this igniter as a replacement for Raypak boilers and pool heaters that require this specific component.

The Raypak gas valve (part 003900F) regulates gas flow to the burner in Raypak heating systems. It is a safety-critical component that controls gas pressure and shuts off flow when the system is not calling for heat. This valve is typically used in Raypak pool heaters and commercial water heaters. When replacing, ensure the valve matches the gas type (natural or propane) and input rating of your system. 3G Electric stocks this part as a direct OEM replacement.

Raypak insulation (part 008406F) is a 1-inch thick Fiberfrax material used to line the combustion chamber or flue passages. To replace, first ensure the system is cool and disconnected from power and gas. Remove old insulation carefully to avoid debris entering the burner area. Cut the new insulation to fit the cavity, ensuring no gaps that could cause heat loss or hot spots. 3G Electric supplies this insulation as a direct replacement for Raypak models that use this specific part.