Topog-E Series 2000 Gaskets – Penta layered high temperature graphite and alloy

[{"filename":"Topog-E-3G-OTH-02632-DataSheet-Rev1-1.pdf","text":"Topog-E® Series 2000 Gaskets\n\n MATERIAL COMPOSITION AND APPLICATION SIZES\nThe steam boiler market makes extreme demands on gaskets; Topog-E® Series 2000 Topog-E® Series 2000 gaskets are\n available in all standard sizes and\ngaskets are specifically designed and fabricated to provide the superior performance\n shapes. Custom sizes and shapes can\nusers of Topog-E® gaskets have come to expect – but at higher operating pressures and be made with short lead times and\ntemperatures. These branded, engineered gaskets provide a cost-effective, reliable, and minimal setup changes.\neasy to use alternative to tacky-cloth, spiral wound and expanded PTFE gaskets.\n MATERIAL\nTopog-E® Series 2000 gaskets can be used as a cost-effective sealing alternative in most Reinforced exfoliated graphite foil\ntypes of higher pressure industrial vessels and tanks that have inspection openings.\nThe proprietary graphite used to manufacture these gaskets gives them exceptional ORDERING\nthermal stability combined with chemical inertness, ensuring superior service capability Please either contact your local\nunder simultaneous conditions of saturated and superheated steam. They provide distributor for Topog-E® Series 2000\nboiler manufacturers, users and service companies handhole and manhole gaskets with gaskets or contact Topog-E® directly\n for details of your nearest distributor.\nunprecedented characteristics.\n SERVICE SUMMARY\nCompared to spiral wound gaskets, Topog-E® Series 2000 gaskets are compressible\nenough to conform to the topography of the mating surfaces – even on old worn and pitted Temperature: up to 636°F (336°C)\n in steam boilers; up to 850°F (454°C)\nflanges – with less torque. Their recovery characteristics are also superior to spiral wound in atmosphere\ngaskets and they are significantly lighter than spiral wound products. Topog-E® Series Pressure: 250-2,000 psig (17-138 bar)\n2000 gaskets are easy to remove and replace with no chiseling or buffing required. Sizes M Factor: 2 (Smooth Flange Surface)\n Y Stress: 900 psi (6MPa)\nare clearly marked on each gasket for easier identification. (Smooth Sealing Surface)\n Max Gasket Load = 24,000 psi (165 MPa)\n\n\n\n\n Topog-E, LLC · 1150 Guadalupe Drive · Cibolo, Texas 78108\n 918-587-6649 · info@topog-e.com · www.topog-e.com\n All information in this data sheet is based on data believed to be reliable; however, we make no guarantee or warranty of the perfor-\n mance of Topog-E® Series 2000 gaskets. Due to numerous application-specific factors that can influence service life, it is always advis-\n able to first test Topog-E® Series 2000 gaskets in a particular application to determine their ultimate suitability."}]